Boundary System 2000TM consists of 3 and 4-foot long adapters. At the
edge they are equipped with transverse holes at 1.5-inches on center. Cemented carbide tipped tools are easily mounted in the holes
(these tools are similar to those used for asphalt planing).
It is important that the tools rotate while in operation to obtain even wear of the cemented carbide tips. To get the tools to rotate
as freely as possible the angle against the road surface should be approximately 40°
Operating Instructions
Put on adapter with provided tools
Tighten bolts with air wrench
Move grader to a flat level surface - not a cement floor
Put down and forward pressure on mold board to take out all freeplay
Roll mold board to achieve angle of 70° on adapter plate which should result in automatic 40° tool to ground surface angle
System 2000TM Carbide Tools
Standard Heavy Duty System (p/n: 2244-28FS) Used in rocky, high abrasion areas. Long life carbide. Recommended for ice blading.
Standard Penetration Tool (p/n: 2244-01FS) Recommended for asphalt planing and oil road reclamation
Heavy Penetration Tool (p/n: 2244-27FS) Improved penetration for oil, asphalt and chemically-treated surfaces. 40-grams of carbide. Long wear life.
Standard Mining Tool (p/n: 2244-28) Used for high abrasion environments. Long life carbide.
Mining Penetration Tool (p/n: 2244-01) Used in high traffic areas for improved ground penetration
Heavy Duty Mining Tool (p/n: 2244-62) For extreme conditions in abrasive rock situations
Boundary System 2000TM consists of 3 and 4-foot long adapters. At the
edge they are equipped with transverse holes at 1.5-inches on center. Cemented carbide tipped tools are easily mounted in the holes
(these tools are similar to those used for asphalt planing).
Standard Heavy Duty System (p/n: 2244-28FS)
Standard Penetration Tool (p/n: 2244-01FS)
Heavy Penetration Tool (p/n: 2244-27FS)
Standard Mining Tool (p/n: 2244-28)
Mining Penetration Tool (p/n: 2244-01)
Heavy Duty Mining Tool (p/n: 2244-62)